Aviom A-16R/A-16CS - Manual (Page 61)

52 A-16R P
eRsonAl
M
ixeR And
A-16Cs C
ontRol
s
uRfACe
u
seR
G
uide
recording device as a SysEx data dump.
Save your
7. MIDI SysEx data to disk or other storage
media used by your MIDI recording device or software
application.
When transmitting a single Preset, the sixteen yellow Mute LEDs in the
channel buttons will light solid for the duration of the transmission to verify
the send operation. For single preset file dumps this will be relatively brief.
Note that there is no way that the A‑16R can know that the MIDI Preset data
file was received properly by the device that the SysEx transmission was
intended for.
Saving All Mix Presets via MIDI
To save the currently saved set of sixteen mix Presets as a single MIDI SysEx
data file:
Make sure that the A‑16R front panel 1. R
emote
/l
ocal
switch is
set to the l
ocal
(MIDI On) position.
Set up your 2. MIDI recording device so that it is ready to
receive MIDI SysEx data.
Hold the A‑16R front panel
3. R
ecall
and G
Roup
buttons down
to enter Save Mode.
While still holding the
4. R
ecall
and G
Roup
buttons, press the
m
ute
button. (You can then release the R
ecall
and G
Roup
buttons.)
The contents of the internal memory of the A‑16R is sent to
5.
the MIDI recording device as a single SysEx data dump.
Save your
6. MIDI SysEx data to disk or other storage media as
used by your MIDI recording device.
During the transmission of the Preset memory, the sixteen yellow Mute
LEDs in the channel buttons will light solid for the duration of the SysEx
transmission.
Note that only the sixteen saved Presets are transmitted as MIDI data. If you
have edited a mix and have not stored it to a memory location in the A‑16R,
this mix will not be recalled when the SysEx data is loaded into the A‑16R
later.