Aviom A-16R/A-16CS - Manual (Page 63)

54 A-16R P
eRsonAl
M
ixeR And
A-16Cs C
ontRol
s
uRfACe
u
seR
G
uide
The A‑16R will remain in MIDI Recall until a valid A‑16R MIDI message is
received, or until another front panel button is pressed to exit MIDI mode.
MIDI SysEx information for other manufacturer’s devices will pass through
the A‑16R and be ignored.
To load an All Preset data file via SysEx:
Set the A‑16R front panel 1. R
emote
/l
ocal
switch to the l
ocal
position.
Press the
2. R
ecall
button. The R
ecall
button LED flashes.
Press the 3. S
olo
button to arm the A‑16R for MIDI reception.
The LED in the S
olo
button will blink.
Send the All Preset SysEx data file from your 4. MIDI storage
device.
The sixteen Presets are loaded into the A‑16R internal
5.
memory sequentially.
The Mute LEDs will serve as a progress bar. The LEDs
6.
will light in order from 1 to 16 as each Preset is received
successfully.
When the All Preset SysEx file transfer is complete, the system will display a
status message to confirm that the data was received properly. Two messages
are possible:
• Valid Data Received ‑ all yellow Mute LEDs will flash
Invalid Data or • MIDI Error ‑ all red Channel LEDs will flash
Press any A‑16R button to acknowledge the transfer status message and
return the A‑16R to normal operation.
Exit MIDI SysEx Mode
You can exit an All Preset SysEx load operation by pressing any A‑16R front
panel button, or by changing the position of the Remote/Local switch.
Presets that have been successfully received prior to exiting the SysEx recall
mode will be preserved in the internal memory of the A‑16R. The remaining
internal Preset memory of the A‑16R will remain unchanged.