Aviom 6416i - Manual (Page 49)

22 F
roNt
P
ANel
F
eAtures
when a signal level of ‑40dB or higher is present. The yellow LED lights when
the signal level reaches ‑10dB. Clipping is indicated with the red LED, which
lights when the level reaches 0dB.
The level meter LEDs will always show the level of the incoming analog audio
signal, even when the channel is not active on the network.
Always try to optimize the input level to assure proper gain staging
throughout both the network and the connected audio devices.
Stereo Link Button
Adjacent pairs of channels on the 6416i can be linked together as a stereo
pair. The channels must be an odd‑even pair, such as 1‑2, 7‑8, etc. There is
one Link button for each channel pair, eight in all.
To link a pair of channels, both channels must be active on the network
first; the Active button below the Gain switch must be lit on both channels.
Once the two channels are active, pressing the l
ink
button will link the two
channels immediately; no confirmation is required.
Attempting to link channels that do not meet the requirements above will
cause the Link button and one or more channel button LEDs to flash to
indicate the error.
To link a pair of channels, both channels must be active first.