Aviom AllFrame - Manual (Page 40)

28 P
owering The
a
ll
f
rame
ALL FRAME
™
Multi-Modular I/O System
DC Power via the Euroblock Connectors
On the top panel of the F6, terminals 1 and 2 of the 6-pin Euroblock terminal connector can be used when
connecting a DC power supply. See the Power Supply Requirements on page 25 for more information about
selecting a properly sized power supply.
The terminal block connector connected to the F6 should be wired as seen in the table below.
Connector Type 2-pin terminal block
Pinout Pin 1: 30-60VDC (+)
Pin 2: Ground (-)
Terminal Blocks Phoenix Contact part number 17 54 44 9
Size: 5mm; 2 contacts per unit
Use a small screwdriver to secure the power supply wires to the terminal block.
To connect a power supply to the terminal block connector:
Carefully remove a small amount (about 1/4-inch, 6mm) of the insulation from each of the 1.
power supply’s wires.
Optionally, tin the ends of each bare wire with solder.
2.
Insert the positive 30-60VDC (+) wire into the 3. P
iN
1 (left) opening in the terminal block.
Secure the wire into place by tightening the screw on the top of the terminal block using a 4.
small screwdriver.
Insert the ground (-) wire into the
5. P
iN
2 (right) opening in the terminal block and secure it
in place by tightening the screw.
Install the terminal block into connectors 1-2 on the top of the F6, pressing the connector
6.
firmly in place.
P N
ote
: Do not connect DC power to any terminal block except #1-2 on the top of the F6 frame.