ChemoMetec NC-250 - Manual (Page 13)

991-0252 Rev. 1.1 February 2013 13
- FTDI device driver installed
- The camera
Due to the intentional and very fast reconfiguration of the camera, you may see an error message
from Windows, which is not of any consequence. Click Close on any of these pop up messages if
needed.
When the NucleoView™ NC-250™ software detects and has initialized the instrument, the previous
red icon changes to true life colors indicating the instrument has been successfully installed.
4. NucleoView™ NC-250™ will display a message box stating successful installation of the instrument,
and recommends that you continue installing this instrument on the remaining USB ports on the
PC. Click ‘Yes’ to do so.
5. You will then be prompted to unplug the USB cable from the USB port on the PC. Do this and click
‘OK’.
6. When NucleoView detects that the instrument has been disconnected, the icon will again turn red,
and you will be prompted to connect the instrument to another USB port on the PC.
7. Repeat the procedure described to install the instrument on the remaining USB ports on the PC.
8. If you are installing more than one instrument on the same PC, you must repeat the USB
installation for all instruments on all USB ports, but note that only one instrument must be
attached at any time.
Installing Licenses and Protocols
Follow the procedure described in the Licenses section to install licenses and protocols. This is not needed
during a normal installation procedure, as licenses and protocols are installed automatically.