COP-USA ASH56NVIR-36S - Manual (Page 17)

13
2.3. Menu setting
¾ With control keyboard or matrix, open the setting main menu through “#64 and #95”
commands. Moreover, the main menu may be also opened by “twice calling #1
preset point” within 4s. And close the menu by “setting #64 or #95” commands.
2.3.1 Main menu
¾ System setting: enter the dome system setting submenu.
¾ Display setting: enter the screen display setting submenu to set the
ID display, preset point header display etc.
¾ Camera setting: enter the camera general parameter setting
submenu to set the parameters of camera.
¾ Montion setting: enter the dome enhancement function setting
submenu.
¾ Privacy Mask: enter the camera blackout setting submenu.
¾ Advance setting: enter the dome high level setting submenu.
¾ System reset: dome reset function. After reset, the dome shall
fulfill the self-check again, after dome reset: 180°auto
pivot-ON/long focus speed restriction-ON/ address
display-ON/angle display-ON/display position top/ dome header
display-OFF/ digital magnification -OFF/ backlight
compensation-OFF/ auto reset-OFF/ reset time -4 minutes/
temperature display OFF.
¾ Exit: Exit the main menu.
2.3.2 System setting
¾
System information: enter the system information display.
¾ Auto flip: dome 180°auto pivot ON/OFF.
¾ Long-focus speed restriction: ON/OFF.
¾ Low power consumption: low power consumption ON/OFF.
¾
Alarm setting: enter the alarm setting submenu.
¾ Alarm numbers: the alarm number is 1 to 4, optional.
¾ Alarm linkage: selection of actions after alarmed. 1 to 50 preset points, the first
MAIN MENU
1 . < SYSTEM SETUP >
2 . < DISPLAY SETUP >
3 . < CAMERA SETUP >
4 . < MOTION SETUP >
5 . < PRIVACY MASK >
6 . <ADVANCE SETUP >
7 . SYSTEM RESET
8 . EXIT
SYSTEM SETUP
1 .SYSTEM INFORMATION
2 . AUTO FLIP : OFF
3 . PROP PAN SPD : OFF
4 . LOW POWER
: ON
5 . < ALARM SETUP>
6 . RETURN
1 . ALARM NO. : 01
2 . ACTION : 1
3 . ALARM : OFF
4 . RETURN
ALARM SETUP
SYSTEM SETUP
1 .SYSTEM INFORMATION
2 . AUTO FLIP : OFF
3 . PROP PAN SPD : OFF
4 . LOW POWER : ON
5 . < ALARM SETUP >
6 . RETURN
CAMERA S/N :
CAMERA ID : 001
PROTOCOL : PELCO -PD
MODEL : S100 P
VERSION : 025
BAUD RATE : 2400bps
SYSTEM INFORMATION
0000000