COP-USA ASH56NVIR-36S - Manual (Page 33)

29
A. on-board type—suitable for general infrared, infrared synchronous on-board pan/tilt
B. Wall-mounted type—suitable for general infrared, infrared synchronous, laser
synchronous general pan/tilt See the detailed description for both mounting modes.
4.7 Installing description
Prior to install:
1) Remove the baseplate of pan/tilt;
2) Refer to address, protocol, baud rate DIP switch diagram, well dial according to the
relevant information;
3) Then reinstall the baseplate of pan/tilt, care to the tightness of waterproof sealing
ring (shown as Fig.2);
Fig.2