COP-USA ASH56NVIR-36S - Manual (Page 22)

18
¾ Whether enable/disable: Edit the auto run enable ON/OFF.
¾ Periodic run: periodic run selection ON/OFF. (After the periodic run started, both
starting time and ending date can’t be modified).
¾ Run function: run function selection, lighting/1 patrol/2 patrol/3 patrol/4 patrol/5
patrol/6 patrol/1self-learning/2 self-learning/ 3self-learning/non/1 line scan /2 line
scan /3 line scan /01 preset point -32 preset points
N OTE：If you want the function of lighting’s fixed time switch to realize through the
schedule settings，the priority level must highest，So you should set the lighting to
NO.01 of the linkage number。The time ,the operative mode of lighting have no
influence with other run functions，can set and run in the same time。
¾
Schedule time setting (set the required date and time as
necessary)
¾ Starting date: setting of starting date.
¾ Starting time: setting of starting time.
¾ Ending date: setting of ending date.
¾ Ending time: setting of ending time.
¾
Schedule duty setting
¾ Sunday-Saturday setting
¾ Saving: after the rule modified, save immediately if want to put into effect.
As changing the linkage number, it is regarded as the giving up of modification.
If the date range is wrong, then it is unable to save, meanwhile
there is the prompt at the left lower corner.
¾ Clear: Clear the settings.
¾
Clear: enter the Clear option setting submenu.
¾ Clear preset header: Clear all headers of preset point.
¾ Clear auto scan: Clear all line scan settings.
¾ Clear patrol trajectory: Clear all trajectory patrol.
¾ Clear self-learning: Clear all trajectory self-learning.
¾ Return the previous menu.
¾ Edit the dome header: set one header for every dome, the dome header may compose
SCHEDULE TIME
1 . START DATE :00-00-00
2 .
3 .
4 .
5 .
RETURN
SCHEDULE DUTY
1 . SUNDAY : OFF
2 . MONDAY : OFF
3 . TUESDAY : OFF
4 . WEDNSDAY: OFF
5 . THURSDAY: OFF
6 .
7 . SATUDAY : OFF
8 . RETURN FRIDAY : OFF
START TIME :00-00-00
END DATE :00-00-00
END DATE : 00-00-00
M OTION SETUP
1 . < PRESETS >
2 . < AUTO SCAN >
3 . < PATROLS >
4 . < PATTERNS >
6 . < CLEAR >
7 . EDIT DOM E LABEL
8 . RETURN
5 . < SCHEDULE >
CLEAR
1 .
2 . CLEAR ALL SCAN
3 . CLEAR ALL PATROLS
4 . CLEAR ALL PATTERNS
5 . RETURN
CLEAR ALL PRE LABEL