COP-USA DVRHD-8D1 - Manual (Page 59)

53
Digital Video Recorder User Manual
6.1.6 Record information
In this interface, a user can check resolution, ftp and record status including sensor alarm recording, motion recording,
manual recording or schedule recording.
6.2 Manual alarm
In this interface, user can check the relevant parameters of manual alarm.
6.3 Disk management
1. Format the disk
Step1: enter into disk management interface
Note: please format the hard disk before record. If not being formatted, it will show the status of the disk-free
space, and total space show OM at the bottom of screen.
Step2: click Refresh button to refresh the disk information of the list box; set the property of the disk then click Apply button
to save the setting
Step3: select a hard disk and click Format button to start format.
Note: all recorded files in the hard disk will be lost after formatted.
2.
Advanced
User may check model, S/N, firmware, health status of the disk in this interface. User also can monitor the temperature,
internal circuit, dielectric material of the disk, analysis the potential problems of the disk and warn so as to protect its data.
6.4 Upgrade
At present, it only supports USB update. Get the software from your vendor when there is a new software version, and
make sure it is corresponding with the DVR. User can check the USB information in Disk management.