Elektron Analog Four - Manual (Page 29)

KITS AND SOUNDS
21
ROTATE For every new coinciding note played, the voices are allocated in a cyclic
manner.
REASSIGN Uses the same voice as last time for every note played as long as its
unused. Otherwise, the least recently used voice is used for the new note.
UNISON Uses all voices to play the same note. Employs the adjustable parameters
DETUNE and PAN SPREAD shown below.
USE TRK SOUNDS forces the selected voices to use the Sounds of the four tracks, instead of
letting the voices use the played Sound in a dynamic way. Tick/untick box to activate/deacti-
vate using the [YES/SAVE] key or the [LEFT] and [RIGHT] arrow keys.
UNISON DETUNE sets the offset (0-127) by which the selected unison voices will be detuned.
Decrease or increase the offset with the [LEFT] and [RIGHT] arrow keys.
UNISON PAN SPREAD set the width of the pan spread (0-127) around the center point of the
unison sound. Use the [LEFT] and [RIGHT] arrow keys to set the value.
If no free voice is found, the least recently used voice is stolen and used for the played note.
See illustration on page 23. This applies to all allocation methods described above.
VOICE ROUTING
Set custom voice routing by accessing VOICE ROUTING, found at the bottom position in the KIT menu.
Activate/deactivate routing of any the four voices to the main output and to the FX track. Navigate using the
[ARROW] keys. Tick or untick box with the [YES/SAVE] key.
Alternatively, instantly activate or deactivate voice to main or voice to FX using the [TRIG] keys 1-4 and 9-12,
respectively. Red LEDs above these sets of keys will indicate if the voice is active (full-bright) or inactive (half-
bright).
Note that voice routing can be set and stored for each individual KIT. If you want to use the GLOBAL voice rout-
ing setting, tick the box USE GLOBAL SETTINGS using the [YES/SAVE] key.