Hardy Floor Scales - Manual (Page 39)

Hardy Floor Scales
30
• Cure to a minimum of 2000 psi before pull-
ing the interface cable through the conduit.
Step 10. Pull the interface cable through the con-
duit.
OPTIONAL
PORTABILITY KIT A portability kit is designed to convert a Hardy Floor
Scale from a stationary scale to a mobile weighing
system for pallets, drums and other large items.
The kit makes it easy to move the scale using a hand
jack or standard forklift tines without damaging the
scale so you can place it where it is needed. Portabil-
ity kits are available in both painted carbon steel and
stainless steel in standard scale sizes.
OPTIONAL ACCESS
RAMPS Optional access ramps are available in carbon steel or
stainless steel. The carbon steel ramps are constructed
of A36 carbon steel floor plate with a skid resistant
tread. The Stainless Steel ramps are constructed of
304 Stainless Steel, diamond tread floor plate. All
ramps are thirty inches (30") (76.2 centimeters) long
in the direction of travel and provide a 5º degree
incline.
Access Ramp
Installation Step 1. Determine which side of the floor scale
you want the access ramp to be placed.
Consider the location of the summing
junction box access plate. It cannot be cov-
ered by the access ramp. (See Fig. 26)
Each carbon steel ramp accessory comes
with two integral foot retainer plates and
four anchors.
Step 2. Place the ramp in position, then lift and set
the platform feet into the foot retainer
plate holes. (See Fig. 25)