Non-c2 loadcell cable connection (j1), 1rq& /rdgfhoo &deoh &rqqhfwlrq, Fig. 3-2 non c2 load cell connection/hi 215it – Hardy WS100 Configuration Software User Manual
Page 14
Chapter 3 - Installation
3-3
3
Do not run load cell cable in parallel with or
in the same conduit with power wiring, relay
cables or any other high energy cables.
4
Remove the factory installed jumpers for C2
wire load cell connection.
5
IT summing Card (Prt. #0535-0465)
Non-C2
Loadcell Cable
Connection
(J1)
1
Attach the load cell cable to the terminal
block mounted next to the J1 connector on
the HI 200DNWM Module.
2
Factory installed jumpers to remain in place
for 4 wire load cell connection.
3
Do not run load cell cable in parallel with or
in the same conduit with power wiring, relay
cables or any other high energy cables.
4
Eight (8) conductor load cell cable required
when:
•
Cable runs are greater than 50 feet.
•
With Soft Calibration
FIG. 3-2 NON C2 LOAD CELL CONNECTION/HI 215IT JUNCTION BOX