Hardy WS100 Configuration Software - Manual (Page 7)

HI WS100 CONFIGURATION SOFTWARE
1-2
ing of all Allen-Bradley SLC 500 products. In addi-
tion the user should understand process control and
be able to interpret ladder logic instructions neces-
sary to generate the electronic signals that control
your application(s).
About Hardy Manuals Every Hardy Installation and Operation manual is
organized into easily referenced chapters, that are
almost always the same:
• Chapter 1 - Provides an introduction to the
instrument and an Overview of the equip-
ment and its capabilities.
• Chapter 2 - Provides a complete list of
Specifications.
• Chapter 3 - Contains information needed to
install the HI 1746-WS (both standard and
optional equipment) and the HI 215IT series
Junction Box.
• Chapter 4 - Provides complete hardware
Configuration instructions for setting dip
switches and jumpers.
• Chapter 5 - Pertains to the firmware/soft-
ware Setup and preparation procedures to
calibrate and operate the instrument.
• Chapter 6 - Provides all Calibration
instructions.
• Chapter 7 - Pertains to the Operating Pro-
cedures of the HI 1746-WS.
• Chapter 8 - Pertains to the Troubleshoot-
ing procedures for repair of the instrument.
Hardy Instruments hopes that this manual meets your
needs for information and operation. All corrections
or suggestions for improvements of this manual are
welcome and can be sent to the Technical Publica-
tions Department or Customer Support Department at
Hardy Instruments Inc.
Description The HI WS100 Configuration Software is a program
that enables the user to configure a remote HI 1746-
WS Weigh Scale Module. The HI 1746-WS Weigh
Scale Module is a self contained microprocessor
based I/O module with control inputs and outputs, that
is designed to be easily plugged into the back plane of