Hardy WS100 Configuration Software - Manual (Page 6)

Chapter 1 - Overview
1-1
CHAPTER 1 - OVERVIEW
A Brief Description of
Chapter 1 This manual provides the user and service personnel
with a description of the specifications, installation,
setup, operation, communication procedures for the
Hardy Instrument’s HI 100WS Configuration Soft-
ware to configure the HI 1746-WS Weigh Scale Mod-
ule, designed for use in Allen-Bradley’s SLC 5/02
©
,
5/03, 5/04, 5/05 programmable controllers. Chapter 1
provides a general introduction to the HI WS100 Con-
figuration Software. The HI 100WS Software is C2
®
and I NTEGRATED T ECHNICIAN (IT)
®
enabled. The HI
100WS Software is designed to run on the Windows
®
95/98/NT/2000 platforms in conjunction with Allen-
Bradley’s RS Linx
©
or RS Linx Lite
©
Industrial Pro-
gramming Software for Windows
®
95/98/NT/2000.
To get the maximum service from this product, users
should operate this software in accordance with rec-
ommended practices either implied or expressed in
this manual. Before using the HI WS100 Software, all
users and maintenance personnel should read and
understand all cautions, warnings, and safety proce-
dures, referenced or explicitly stated in this manual.
Hardy Instruments appreciates your business. Should
you not understand any information in this manual or
experience any problems with the product, please
contact our Customer Support Department at:
Phone: (858) 278-2900
FAX: (858) 278-6700
e-mail: [email protected]
Web Address: hardyinst.com
NOTE: C2
®
, I NTEGRATED T ECHNICIAN
®
are registered trade-
marks of Hardy Instruments Inc. Windows
®
is a regis-
tered trademark of the Microsoft Corporation.
RSLinx
©
and RSLinx Lite
©
SLC 500
©
are registered
trademarks of the Rockwell Corporation.
NOTE: Hardy Instruments bases all procedures on the
assumption that the user has an adequate understand-