Holtgreven Ohaus Defender Series Bench Scales - Manual (Page 44)

EN-42 5000 Series Indicators
3.13.5 Lock Print Button
Set the status.
OFF = Print button is unlocked.
ON
= Print button is locked.
3.13.6 Lock Unit Button
Set the status.
OFF = Unit button is unlocked.
ON
= Unit button is locked.
3.13.7 Lock Function Button
Set the status.
OFF = Function button is unlocked.
ON
= Function button is locked.
3.13.8 Lock Mode Button
Set the status.
OFF = Mode button is unlocked.
ON
= Mode button is locked.
3.13.9 Lock Tare Button
Set the status.
OFF = Tare button is unlocked.
ON
= Tare button is locked.
3.13.10 Lock Menu Button
Set the status.
OFF = Menu button is unlocked.
ON
= Menu button is locked.
NOTE: When the Menu button is locked, the user may unlock this button by holding the Menu button for 10
seconds until UNLOCK is displayed. The hardware Lock Switch must be in the unlocked position.
3.13.11 End Lock
Advance to the next menu.
3.14 Security Switch
A slide switch is located on the Main PCB board. When the switch is set to the ON position, user menu settings that were locked
in the Menu Lock and Key Lock menus can be viewed but not changed.
Open the housing as explained in Section 2.3.1. Set the position of security switch SW2 to ON as shown in Figure 1-3.