Holtgreven Ohaus Defender Series Bench Scales - Manual (Page 46)

EN-44 5000 Series Indicators
4.8 Application Modes
Press and hold the FUNCTION Mode button until the desired application mode appears. Only modes
enabled in the mode menu will be displayed (refer to Section 3.6).
4.8.1 Weighing
Place the item to be weighed on the scale. The illustration indicates a sample of 1.5 kg, Gross weight.
NOTE: Press the FUNCTION Mode button to temporarily display the weight in 10x expanded resolution.
4.6 Changing Units of Measure
Press and hold the PRINT Units button until the desired measuring unit appears. Only measuring units enabled in the Unit Menu
will be displayed (refer to Section 3.7).
4.7 Printing Data
Printing the displayed data to a printer or sending the data to a computer requires that the communication parameters in the Print
and Communication Menu are set (refer to Sections 3.9 and 3.10).
Press the PRINT Units button to send the displayed data to the communication port (the Auto-Print Mode in Section 3.9 function
must be Off).
4.8.2 Parts Counting
Use this mode to count parts of uniform weight. The Indicator determines the quantity based on the average
weight of a single part. All parts must be uniform in weight for accurate measurements.
Establishing the Average Piece Weight (APW)
When the FUNCTION Mode button is released, CLr.PW Pcs is displayed.
Clearing a Stored APW
Press the Yes button to clear the stored APW.
Recalling a Stored APW
Press the No button to recall the existing APW.
NOTE: Press the FUNCTION Mode button to temporarily display the APW value.
The display shows the sample size PUt 10Pcs.
Е
Е