Holtgreven Ohaus Defender Series Bench Scales - Manual (Page 48)

EN-46 5000 Series Indicators
4.8.4 Check Weighing
Use this mode to determine if the weight of a sample is within prescribed limits.
Checkweighing Limits
When the FUNCTION Mode button is released, CLr.rEF is displayed.
Clearing Stored Check Weighing Limits
Press the Yes button to clear the stored limits.
Recalling Stored Check Weighing Limits
Press the No button to recall the stored limits.
NOTE: Press the FUNCTION Mode button to temporarily display the Under and Over Limit values.
Editing the Under Setting
The display shows SEt.LO. Press the Yes button to edit setting..
Settings:
-999950 to 999950
Refer to Menu Navigation Section 3.2 to enter settings.
NOTE: The minus sign is used together with the first digit to show a negative value.
Editing the Over Setting
The display shows SEt.HI.
Press the Yes button to edit the Over setting.
Settings:
-999950 to 999950
Refer to Menu Navigation Section 3.2 to enter settings.
Begin Check Weighing
The appropriate Under, Accept or Over LED lights to indicate Check Weigh status.
Place a sample on the scale and read the weight.
For loads less than the Under Limit, the yellow Under LED is lit.
For loads greater than the Under Limit and less than the Over limit, the green Accept LED is lit.
For loads greater than the Over Limit, the red Over LED is lit.
to
Е
Е
Е
Е