ALTANA BYK-mac COLOR Manual - Manual (Page 57)

56
Cleaning the Black Trap
From time to time the black trap should be cleaned
with clean, dry air to remove any dust or
contamination.
The black trap is taken apart by compressing the
lower part on both sides of the case with your
fingers, and then separating the two sections.
The black glass should be cleaned using a clean,
lint-free cloth. In the second step, wipe off the glass
with alcohol. You must let the glass dry completely
before taking a black trap reading.
Exact calibration is not possible unless the
standard is in perfect condition. If the condition of
the standard seems doubtful because of its
appearance or measurement errors, we will be
happy to check it for you.
Cleaning the Bottom Plate
Please use only the cleaning set included with
the instrument.
Place the instrument on the white paper pad.
Repeat placing the instrument several times to
make the pins grease-free.
Then place the instrument on the blue rubber mat.
Repeat placing the instrument several times to
make the pins lint-free.
Do not drag the instrument over the surface!
Please make sure that all rubber pins are still
attached after cleaning.
Clean the blue rubber mat with Isopropanol and a
microfiber cloth.
Cleaning and Maintenance
White paper pad
Blue rubber mat