ALTANA LC 4 - Manual (Page 39)

BYK LC 4 Operation
39
4.10.4 Timer
The timer function can count down the seconds of a specified time interval
(timer intervall) of maximum 59:59 (minutes:seconds). When the specified
timer interval has expired, an alarm signal sounds for one minute and the
display flashes.
3 Display the current time as an intermediate time with < L>.
The intermediate time is displayed under the running stopwatch.
4 Stop the stopwatch with < g>.
5 Let it continue with < g>.
or
Reset the stopwatch to 00:00 with <
R>.
or
Terminate the stopwatch and switch to the measuring mode display
with <
E>.
1 Display the stopwatch with < U_>.
The v status indicator appears.
The stopwatch is on 00:00.
2 Select the minutes or seconds with < 5_> or <6_> [<Minutes> or
<Seconds>].
The selected display flashes.
3 Set the timer interval (minutes:seconds) with < >> and <<>.
The stopwatch has been converted to a timer.
4 Confirm the setting with < g>.
5 Start the timer with < g>.
6 If necessary, display the remaining time as an intermediate time with
<
L>.
nLF
Tref25
MEM
CAL
RCL
Sal
1 cm
K
C
2 5 8
S/cm
TDS
CellTC
S
SAL O
2
TC
RESET
Cell
LAP
m
mbar
mg/l
CAL
STO
LoBat Day.Month h:min Ident Lap
8
CLR
Lin
Tref20 Tref20
M cm
k cm
ESC
0 5 0 9
min:s