Carl Goldberg GBGA1084 User Manual
Page 12
12
Wild Stick 120
4.Take one of the 7” pushrods and
make sure the clevis is screwed on
with about 1/16” of threads showing
on the inside. Install the clevis on the
angle bracket and mark the location
over the hole on the fuselage brack-
et. Make a 90 degree bend and cut at
3/8”. install the wire in the aluminum
fuse bracket and retain with the
nylon swing in keeper. Adjust the
length so you don’t pull the stab out
of alignment.
5.Repeat for all four wires on the bot-
tom side.
6.Take the 10” pushrods and attach to
brackets on stab. Bend 90 degrees at
brackets on fin and cut to 3/8”.
Retain with nylon swing in keepers.
Repeat for other side.
7.After all wires are installed they
can be adjusted by putting a level in
the center of the stab and leveling
the plane. Move the level to the tip of
the stab and adjust wires till level.