Carl Goldberg GBGA1084 - Manual (Page 14)

14
Wild Stick 120
Tail wheel
Locate the following Parts:
Tail wheel bracket
tail wheel
rudder tiller arm
wire axel
3mm wheel collar
nylon control horn brackets 2
springs 2
tail wheel tiller arm
tail wheel tiller arm collar
2mm screws 5
2mm washers 5
1. Insert the tail wheel wire into the
bracket and fit the collar on
top.align the hole for the tiller arm
so it is parallel to the axel.
2. Center the tiller arm in the collar
and tighten the set screw. Screw the
nylon horn brackets on each end.
Install the tail wheel using the 3mm
collar to retain.
3. Mount the bracket flush with the
rear of the fuselage using the three
screws.