Carl Goldberg GBGA1084 - Manual (Page 21)

21
Wild Stick 120
5. Slide the 5mm plastic tube on the
throttle pushrod until it extends
1/4” through the firewall. Install
the pushrod connector on the servo.
Open the throttle full and set the
throttle servo to full. Tighten the
set screw on the pushrod connector
onto the pushrod. Cut the pushrod
off about 1/4” pass the connector.
The throttle can be adjusted by loos-
ening the screw on the pushrod con-
nector if necessary.
nylon tube
4. locate the pushrod connector and
attach it to a servo arm. It has a
washer on top of the arm, the bottom
of the arm, then install nut. Use a
drop of CA glue on nut to make sure
it does not come loose. Make sure the
pushrod connector will rotate in the
servo arm.
Elevator servos
Collect the following items:
3mmx20 pushrods 2
3mm nuts 4
3mm clevises 4
silicone clevis keepers 4
1. Install the elevator servos in each
side of the fuselage using the hard-
ware supplied with the radio.
2. Thread a nut and clevis on each
end of the two elevator pushrods.