Carl Goldberg GBGA1084 - Manual (Page 6)

6
Wild Stick 120
BUILDING
INSTRUCTIONS
Before starting to build this kit, we
urge you to read through these
instructions. They contain some
important building sequences as well
as instructions and warnings con-
cerning the assembly and use of the
model.
We expect that you have some build-
ing experience to take on this model.
However, every minute detail is not
covered. This is not a basic trainer.
The instructions together with the
simplicity of this kit will allow you to
produce a first class Wild Stick 3-D.
BUILDING SUPPLIES NEEDED
Hobby knife w/ #11 blade
Thin Zap CA
30 Minute Z-poxy
Thread lock
Wire cutters
Pliers
Drill with bits: 1/8", 5/32", 1/16”
5/64”
Phillips and standard screwdriver
Small clamps
Masking tape
Tape measure
Washable marker
Paper towels
Rubbing alcohol
Wing Construction
Collect the following parts:
1. left and right wing panel
2. dihedral brace
3. wing holddown bolts(2)
1. Trial fit the dihedral brace in the
slot on one wing. The wing is flat (no
dihedral) so the brace should fit
either way. Slide the other wing
panel in place and make sure the
joint in the center is closed.
2. Mix some 30 minute epoxy and
spread on all sides of the dihedral
brace, front back and edges.