Carl Goldberg GBGA1084 - Manual (Page 7)

7
Wild Stick 120
3. Spread epoxy on the root rib of
each wing panel. Use a thin scrap of
wood and work some of the epoxy
down into the slots for the dihedral
brace on each panel.
4. Use masking tape to hold the wing
panels firmly together while the
epoxy set. Lay the wing flat on the
floor or work bench while the epoxy
cures. Do not stand the wing on one
tip, all the glue will run to one end
and give you a poor joint.
5. locate the two 4mm x 40mm bolts
and two 4mm flat washers.
6. After the epoxy has cured, bolt the
wing in place on the fuselage..
Tail construction
locate the following parts;
1. stabilizer with elevators
2. Fin with rudder
3. Nylon control horns
4. nylon nut plates
5. 2mm x 20mm screws
6. Silicone clevis keepers
1. locate the control horns on the
inside edge of the elevators on the
bottom side. make sure the holes for
the clevis are aligned over the hinge
line. Mark the location of the holes
and drill a 3/32” hole at the four
locations. use the 2mm screws and
nut plates to mount the control
horns.