Carl Goldberg GBGA1084 - Manual (Page 9)

9
Wild Stick 120
7. use a razor blade or e-xacto knife
to carefully remove the covering
inside the marks on the bottom of the
stab. Cut carefully so as not to cut
the wood, just the covering.
8. mix some 30 minute epoxy and apply
to the bare wood on the bottom of
the stab and in the slot on the rear
of the fuse. Reinstall the stab and
check to make sure it is square. use
pins to hold in place. Check the
alignment with the wing by sighting
from the front and rear. Apply pres-
sure to one side if necessary to make
stab parallel to wing.
remove covering
9. Remove the covering from the bot-
tom portion of the rudder where it
plugs into the stab.
remove covering
10. Fit the fin in place and make a
mark around it. Remove the covering
inside the marks on both the stab and
the rear portion of the fuselage
behind the stab.