Understanding ine sounds you may hear, Saving energy, Time – Whirlpool ED20TWXDN02 User Manual

Page 23: Nderstanding, Sounds, Hear, Aving, Energy

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

USING YOUR REFRIGERATOR

U

nderstanding

ine

sounds

you

may

hear

Your new refrigerator may make sounds that your
old one didn’t make. Because the sounds are new
to you, you might be concerned about them. Most
of the new sounds are normal. Hard surfaces, like
the floor, walls, and cabinets can make the sounds
seem louder than they actually are. Due to new

product designs, there may be sounds that you are
not familiar with. The following describes the kinds

of sounds that might be new to you, and what may
be making them.

• Your refrigerator is designed to run more effi­

ciently to keep your food items a the desired
temperature. The high efficiency compressor may
cause your new refrigerator to run longer than
your old one, and you may hear a pulsating or
high pitched sound.

• Water dripping on the defrost heater during a

defrost cycle may cause a sizzling sound.

• If your product is equipped with an ice maker,

you will hear a buzzing sound when the water
valve opens to fill the ice maker for each cycle.

• You may hear the evaporator fan motor circulat­

ing the air through the refrigerator and freezer

compartments.

• As each cycle ends, you may hear a gurgling

sound due to the refrigerant equalizing in your
refrigerator.

• The defrost timer will click when the automatic

defrost cycle begins and ends.

• The thermostat, refrigerator control, will click

when cycling on and off.

• Rattling noises may come from the flow of

refrigerant, the waterline, or items stored on top
of the refrigerator.

• Contraction and expansion of the inside walls

may cause popping and cracking noise.

S

aving

energy

There are ways that you can help your refrigerator

run more efficiently.

• Check the door gaskets for a tight seal. Leveling

the cabinet will ensure a proper seal.

• Clean the condenser coils regularly A coil

cleaning brush is available for purchase (part
number 4210463).

• Open the door as few times as possible.

• Don’t block the air vents in the freezer and

refrigerator so that cold air cannot flow freely.
(see page 13.)

• Do not set your refrigerator and freezer at a

colder setting than is needed. Keep the
refrigerator control at the lowest number setting
that keeps your ice cream firm and your drinks as
cold as you like.

• Do not put your refrigerator next to a heat source,

such as a range, water heater, furnace, radiator, or
in direct sunlight.

Time

TIP

Save energy

Organize your food in your refrigerator and
think about what you want before you open
the door. This will allow you to get every­
thing In one trip and will help save energy.

23

Advertising