Tile la dispenser will not operate properly – Whirlpool ED20TWXDN02 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING CUIDE
TilE la DISPENSER WILL NOT OPERATE PROPERLY
Check if...
Then...
The freezer door is not closed completely.
Push the door firmly shut. If it will not shut all the way,
see "The doors will not close completely,” on page 35.
The ice bin is not installed correctly.
Push the ice bin in all the way. If the ice bin does not
go in all the way, it may not be put in straight. Pull it
out and try again.
The wrong ice has been added to the bin.
Use only cubes produced by the current ice maker. If
other cubes have been added, remove all cubes and
check to see that none have become stuck in the
delivery chute.
The ice has frozen in the ice bin.
Shake the ice bin to separate cubes. If cubes do
not separate, empty bin and wait 24 hours for ice
to restock.
The ice has melted around the auger (metal
spiral) in the ice bucket.
Dump the ice cubes and clean the ice bucket com
pletely. Allow 24 hours for the ice maker to re-stock.
Do not try to remove the melted ice with a sharp
object. You could damage the ice bucket.
Ice is stuck in the delivery chute.
Clear the ice from the delivery chute with a plastic
utensil. Do not use anything sharp to remove the ice.
You could cause damage.
There is no ice in the bucket.
See “How the controls work,” on page 12.
The dispenser arm has been held in too long.
Release dispenser arm. Ice will stop dispensing when
the arm is held in too long. Wait three minutes for
dispenser motor to reset before using again. (For
future use, take large amounts of Ice directly from
the ice maker so that the dispenser arm is not held in
too long.)
32
1-800-253-1301
WITH QUESTIONS OR COMMENTS