Whirlpool ED20TWXDN02 - Manual (Page 7)

iNSTAiuNC Y
our
R
efricerator
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.
U
npacking
YOUR REFRICERATOR
Removing packa^in^ materials
Remove tape and any labels from your refrigerator
before using (except the model and serial
number label).
To remove any remaining tape or glue, rub the
area briskly with your thumb. Do not use sharp
instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners. These products can damage the
surface of your refrigerator. For more information,
see “Important Safety Instructions” on page 3.
NOTE: Do not remove any permanent instruction
labels inside your refrigerator, or the Tech Sheet
that is fastened under the front.
Cleaning before use
After you remove all of the packaging materials,
clean your refrigerator before using it if
needed. See the cleaning instructions
on page 24 for more information.
Time TIP
Easy clean up
Tape or glue residue can also be easily
removed by rubbing a small amount of
liquid dish soap over the adhesive with
your fingers. Rinse with warm water and dry.
I
E
lectrical
REQUIREMENTS
Before you move your refrigerator into its final
location, it is important to make sure you have the
proper electrical connection.
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused,
grounded electrical supply is required. It is recom­
mended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot
be turned off by a switch. Do not use an extension
cord. Refer to the Electrical Requirements and
Grounding Instructions Sheet in your Literature
Package for more details.
NOTE: Before performing any type of installation,
cleaning, or removing a light bulb, turn the
Refrigerator Control to OFF and then unplug the
refrigerator. When you are finished with any of
these steps, plug the refrigerator in and reset the
Refrigerator Control to the desired setting.