The water dispenser, The dispenser light, Solving common ice dispenser problems – Whirlpool UPRIGHT FREEZER User Manual

Page 22: Problem, Possible cause/solution, Ice dispenser will not work, Ice dispenser stops working

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

The water dispenser

Chilled water comes from a tank behind the

meat drawer. It holds approximately 1

'/2

quarts (1.5 L).

When the refrigerator is first hooked up,

press the water dispenser bar with a glass

or jar until you draw and discard 2 or 3

quarts (1.9 to 2.8 L). The water you draw

and discard rinses the tank and pipes.

Allow several hours to chill a new tankful.

NOTE:

The small tray beneath the dispenser

is designed to evaporate

small

spills. There

is no drain in this tray.

Do not

pour water

into it.

To dispense water:

1

■ Press a

sturdy

glass against the water

dispenser bar.

2. Remove the glass to stop dispensing.

NOTE:

Dispense enough water every week

to maintain a fresh supply.

The dispenser light

To turn on night light,

slide dispenser

LIGHT switch to the left. See page 26

for directions for changing the dispenser

light bulb.

r

Solving common ice dispenser problems

PROBLEM

POSSIBLE CAUSE/SOLUTION

Ice dispenser

will not work

’ Freezer door is open.

’ Ice bin not properly installed. Make sure the bin is pushed in all

the way.

'Wrong ice in bin. Only use crescents from the ice maker.

Shake the bin occasionally to separate cubes and increase

storage room.

’ Dispenser not used for extended periods of time, causing ice

cubes to melt together. Dump old ice and make a new supply.

Ice dispenser

stops working

’ Ice dispenser bar held in too long. Wait about three minutes for

dispenser motor to reset.

’ Large amounts of ice should be taken from the bin, not through

the dispenser.

21

Advertising