Extra recharge, Program memory, Error code – Kenmore 625.34847 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SECTION 2

HOW YOUR WATER SOFTENER WORKS

2A.

face

plate

timer

features

EXTRA RECHARGE

Sometimes, a manually started regeneration (re­
charge) may be desired, or needed- Two exam-

Д frl Д- Vw •

— You have used more water than usual (guests
visiting) and you may run out of soft water before
the next timer started regeneration.

— You did not refill the softener with salt before it

was gone.

You can start a regeneration right away, or you can
set the timer to regenerate at the next 2:00 AM (or
other preset recharge time), Do the following

RECHARGE

NOW

Ш

Press the ON/OFF---HOLD button and

hold

for 3 seconds

RECHARGE

NOW begins to flash in the
display, and the softener en­
ters the fill cycle of regenera­
tion right away This regeneration will last for
about 2 hours Then, you will have soft water
again-

RECHARGE

TONIGHT

H Press and release (do mot hold) die ON/

OFF-HOLD

button

RE­

CHARGE TONIGHT flashes
in the display, and the soften­
er begins regeneration at the
next preset recharge time. If you decide to can­
cel the regeneration before it has started, press
and release the ON/OFF-HOID button once
more to turn off the flashing RECHARGE TO­
NIGHT

3

“ ^3 I

RECHARGE NOW

PROGRAM MEMORY

If electrical power to the softener goes off, the
time display is blank but the face plate timer keeps
the correct time for about 6 hours. When electrical

power comes on again, you have to reset the
present time oaly if the display is flashing. The

HARDNESS and RECHARGE TIME never require
resetting unless a change is desired.

Even if the timer is inconect after a long power-
outage, the softener works as it should to keep
you water soft. However, regenerations may occur
at the wrong time of day until you reset the timer
to the correct time of day

ERROR CODE

An error code could appear in the face plate
display if a problem occurs in the softener
electronics. If you see an error code instead of the
lime of day, please call you local Sears Service
Department for service

Err

и i

IF YOU NEED HELP ON THE USE OF THE TIMER FEATURES, CALL TOLL FREE,

NUMBER 1-800™ 426-9345,

'

10

Advertising