Check list of all step-by-step guides to install, Heater – Kenmore 625.34847 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION
1
WATER SOFTENER START-UP
IB.
CHECK LIST OF ALL STEP-BY-STEP
GUIDES
TO
INSTALL
Refer to the Installation Manual, part no. 7159931,
for step-by-step guides*
To be sure you have done all the steps to install the
softener, read the following list. Page numbers
referred to are in the
InstaEation MammL
✓ Is the house water supply flow going iato
the softener valve INIET? Trace piping to be
sure. See pages 10 and 11*
^
Is the plumbing bypass valve (or 3 valves) set
for soft water service? See page 18,
%/
Is the valve drain hose connected to the drain
fitting the right way? Does the drain hose run to
the drain point without sharp bends or kinks
that could stop or reduce water flow? See page
16
Is the softener power cable connected to the
transformer, and is the transformer plugged
into an inside, 120V-60Hz electrical oudet?
See page 20,
%/
Be sure to restart the water heater. See page 20.
iV'-'
Water
Heater