Kenmore 19501 - Manual (Page 34)

■
-
'.
o Stitch Length Button
This button sets the stitch length tor both straight and zigzag stitches.
When you press the stitch length button, the stitch length light will go on and
the indicator screen will show the pre-set stitch length;
" 2 .0 " for straight stitching
"1.5" tor zigzag stitching
NOTE; The range of stitch length depends on the stitch pattern you select.
Press the " button.
The stitch length will decrease
— by 0 .1 mm from "1 .0 " down to "0 .0 "
— by 0.5 mm from "4.5" down to "1.0"
To Increase the Stitch Length:
Press the "+" button.
The stitch length will increase
— by 0 .1 mm from "0 .0 " up to "1 .0 ".
— by 0.5 mm from "1.0" up to "4.5",
To Adjust the Stitch Length Quickly:
Hold Down the "+" or " button until you reach the length you desire.
To Return to the Preset Stitch Length:
(or clear the stitch length setting)
Press the Stitch Length button again (or press the Clear button). The stitch
length light and the indicator screen will go off.
33