Buttonholes h ~ @ (continued) – Kenmore 19501 User Manual
Page 69
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Buttonholes H ~ @ (Continued)
• Adjust the Stitch Density
You can adjust the stitch density of the entire
buttonhole or of only one side.
The stitch length button controls the stitch
density. It IS pre-set at "0.4"-
Set the Machine
SECTION 5. LEARN THE STITCHES
1 3 E O S i
Stitch Density m Entire Buttonhole:
Press
or
to
adjust
the
stitch
density
ot
the entire buttonhole.
For Condition A;
Lett Side Stitches too Far Apart
(see above)
Turn the feed balance dial slightly
toward
"
Use
the
large
screw
driver in your accessory box.
B
For Condition B:
Right Side Stitches too Far Apart
(see above)
Turn the feed balance dial slightly
toward "+"
After adjusting the feed balance dial, sew another test buttonhole to be sure
your adjustment is correct.
NOTE; Remember to turn the feed balance dial to the standard mark
{ ► ) when you have completed your buttonholes.
68