Kenmore 88963 - Manual (Page 7)

INSTALLATION
Install your oven by iollowins these four simple steps:
Step 1: Remove ail packing materia! and accessories. Then remove the protection sheet on wrapper.
Step 2: Place the oven in the level location of your choice, but make sure there is at least one inch of
space on the top and at the rear for proper ventilation. Top of the oven should be kept dear and
the plastic feet must be kept on the oven so there is air flow ventilation. The exhaust vents are
at the rear and top of the oven. “DO NOT place any objects such as books, papers, or
cooking accessories over the top of the exhaust vents ’* Blocking the vents can damage the
oven.
Step 3: Plug your oven into a Standard 120 volt household outlet. Be sure the electrical circuit is at least
15 amperes and that your microwave/convection oven is the only appliance on the drcu'rt.
Step 4: When your microwave/convection oven is plugged in for the first time or when power resumes
after a power interruption, the numbers in the display window will show “ 0 ; 00 " plus the hours and
rmnutes that have elapsed since the oven was plugged in or the power was restored. This means
that tl e TIME OF DAY dock must be set. Refer to "Setting Tane of Day" below.
NOTE: If your oven does not operate properly, unplug the oven from the 120-volt household outlet and
then plug it back in.
This unit is not designed for 50 Hz or any circuit other than a 120 voit/60 Hz AC circuit,
SETTING TIME OF DAY
« Touch CLEAR,
• Touch TIME OF DAY.
» Touch numbers indicating the correct time.
» Touch TIME OF DAY.
(This is also explained in the “Easy Use Chari” Time of Day Section on Page 12.)
DIMENSIONS
Height: 15-3/4
Width: 24'
Depth: 21'
Weight:
68 lbs.
When one side is
installed flush to
the wall, the opposite
side or top must be open.