Canon W8200 - Manual (Page 149)

Message Is Displayed
17
7-17
Media Too Large
Problem 1: The loaded media is larger than any media size allowed for loading in the
printer.
Solution: Set the correct size media then try again. ( Æ P.2-8, P.2-19)
Media Skewed
Problem 1: The loaded media is skewed.
Solution: If roll media is in use, open the upper cover, raise the paper release lever,
open the roll media tray, take-up some of the media manually to correct the
skew then try again. (
Æ P.2-8)
Solution: If a cut sheet is in use, open the upper cover, raise the paper release lever,
remove the cut sheet, set it again then retry. (
Æ P.2-19)
Media Too Small
Problem 1: The loaded media is smaller than any media size allowed for loading in the
printer.
Solution: Set the correct size media then try again. ( ÆP.2-8, P.2-19)
Media Jam
Problem 1: Media has jammed in the printer.
Solution: Remove the jammed media then press the Online button. ( Æ P.7-19)
Incorrect Media
Problem 1: The media type specified by the printer driver does not match the value for
the media in the paper feed source.
Solution: Confirm the type of media loaded in the printer, then select the media type
with the operation panel. (
Æ P.2-18, P.2-26)
Solution: Pause the print job, use the printer driver to correct the media type so it
matches the loaded media, the re-start the job.