Canon W8200 - Manual (Page 20)

Before Using the Printer
4
1-4
d Slot
Provided for installation of either the USB 2.0 or IEEE1394 expansion
board. To install, remove the two screws. (
Æ Setup Guide)
e Power connector
Provides a connection point for the printer power cord.
f Media Take-up Unit connector
Provides a connection point for the power cord of the Media Take-up
Unit.
TTop View (Inside)
a Guide rail
An important part for the movement of the carriage.
b Carriage rail
Provides the path for the carriage as it moves from side to side.
c Paper restraint
Required for media and paper output in the paper path.
d Platen
Supports the paper from below while the printhead moves from side to
side on the surface of the paper during printing.
e Paper release lever
Releases the media in the paper path. Upper this lever to open the paper
restraint when you need to load a cut sheet, feed a cut sheet manually, or
clean inside the printer. (
Æ P.2-21)
b
a
e
c
d