Canon W8200 - Manual (Page 25)

Switching the Printer On and Off
9
1-9
Switching the Printer On and Off
Follow the procedure below to switch the printer on and off.
The examples below demonstrate normal operation of the printer after it is
set up and ready for normal operation. If the printer has not been set up
completely, follow the procedures in the Setup Guide to complete the setup
procedures before you execute the procedures below.
Switching the Printer On
Switch on the printer before you execute a print job from the computer.
1
Press the Power button.
The Online lamp and Message lamp flash for a few seconds while the printer
warms up. After the printer has warmed up, if media is loaded in the printer
the Online lamp lights and remains on, and “Online” is displayed. The
printer is ready to print.
If no print media is loaded in the printer when the printer is switched on,
“Offline” is displayed and the printer waits for you to load media in the
printer.
The Message lamp flashes when a message is displayed. Read the message
and perform the required procedure. (
Æ “Message Is Displayed” P.7-13)
If the display or Online lamp do not light, check the power cord connections
at the printer and the power supply and make sure that they are secure.
(
Æ Setup Guide)
Enter Cancel
Cut Sheet
Roll Media
Paper Source Data Message Power
Online
Enter Cancel
Cut Sheet
Roll Media
Paper Source Data Message Power
Online
Online