Listening to tapes, Playing a single tape, About the direction indicators – Kenwood 855 AV User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Listening to tapes
Playing a single tape
Before starting, be sure that the TIMER switch.is OFF.
1 Insert a tape into a cassette well. The tape type
(Normal or Chrome) is automatically selected.. .
2 Set the play mode.
ci) plays both sides of the .tape repeatedly.
> ) stops after playing both sides of the.tape.
___ stops after playing I side of the tape. -
3 Set the Dolby Noise Reduction mode, by moving the
switch to the proper setting for the tape .you’re
playing. For example, If your playing a .tape recorded
using Dolby C, select Dolby C.
4 If you're using the remote, press the AUDIO button
on the remote until the remote's display shows TAP
A or TAP B (depending on which, you're listening to).
5 On either the remote or the cassette deck’s front
panel, press the ◄ or ► button (depending on .which
side of the tape you want to listen to) to begin play.
6
Pr^ess the ■ button on either the remote or.the.
cassette deck’s front panel to stop play.
About the direction indicators:
The ◄ and ► indicators show the direction the tape is .
moving. If you turn the power OFF, the tape plays in the
same direction when you turn the power back ON.
37.