Kenwood 855 AV - Manual (Page 45)

5 Press the EDIT MODE button again...................
6 Select the CD you want to tape using the DISC
SELECTOR buttons. - ■ -
7 Select the. tracks to tape using the TRACK SKIP
buttons. ■■
If you make a mistake, press the CLEAR button, and
select the correct track . ■ : '
8 Press the P.MODE button after each track selection. '
The display shows the time remaining on Side-A!
If the time remaining on Side-A is shorter than the
track you selected, that track is programmed onto
Side-B. When B-FULL is displayed, both sides are full,
9 To tape from more than I CD, repeat steps 6
through 8. , .
to To tape, press the-CCRS.button on the cassette deck
Recording begins after about I minute. For an expla­
nation .of CCRS, see page 42.
Checking the tracks you’ve selected
For a single CD, press the CHECK button. The track
numbers of the selected tracks are automatically
displayed.
For multiple CDs, press the,CHECK button. Each time
you press the button, you advance the display to the
next track number.
Clearing tracks from the selection
For a single CD, press the P.MODE or the
OPEN/CLOSE button.
For multiple CDs, press the P.MODE button,
.ill
i. ~l
r
.
45.