Toshiba KV-6200A - Manual (Page 21)

R
e c o r d i n g o p e r a t i o n
Turn on the power for this unit as well as associated
devices of the surveillance system including the video
camera and monitor TV.
Insert a video cassette to this unit.
• Check that the safety tab on the video cassette has
not been removed.
Adjust the monitor TV so that the picture from the
video camera is displayed properly.
I.I.ltL
6
Select the recording time mode.
3 Check that the date time display on the monitor TV is
correctly displayed.
A / 1«3T>^U
2
thie mcoe
nn n n
u u u u
Q
n
H
1 ?
0 §
Press the REC button.
REC
Iñecl
>■
n n n n
U Ü u u
R
H
г
Set the various functions such as timer recording,
alarm recording, restart recording, tape end, etc.
(9Z
ZO
O H
flC<
8 £
zo
Notes:
When ItTB PAUSE button is pressed during recording, the unit goes to the pause mode. To release, press either the PAUSE
button again or the REC button. When the pause mode continues for 10 minutes the unit goes to the stop mode.
Repeat recording, restart recording, alarm recording, etc. also operate during recording.
When the unit is stopped during recording or the recording time is changed, the pictures may be disturbed at that location.
In case of power failure restart recording, if a power failure should occur and it is within approximately 10 days in length, it is
possible to resume recording in the same time mode after power failure is recovered.
During repeat recording, pay attention to the following points.
• Timer recording and alarm recording is not possible during automatic rewind.
■ The buzzer does not sound even at tape end.
• When an operation button is pressed during automatic rewind, the repeat recording function does not operate. Reset to the
recording mode.
The button is not accepted during alarm recording or timer recording.
When carrying out repeat recording or timer recording, be sure to cany out daily checks.
20