Toshiba KV-6200A - Manual (Page 27)

It is possible with this unit to carry out One-shot recording to record only when there is a trigger input from outside or for use as a
data fiie. If a trigger is input to the One-shot input on the back, there will be recording for the field numbers set at the time interval
set.
----------- Connecting the One-shot terminal -----------------
To One-shot in
ToGND
Consult with your dealer about the remote control switch.
Operation of One-shot Recording
Press the A TIME MODE button to select L01, L02 or
L03.
X
n n n n
u u u u
I n i
!_ U I
0 ^
Press the DISPLAY
button.
D9UY S№ - m *
LOOtflQN KLECr
J J 0 0 G D
CLOCK ADJUST
SETUP
DISPLAY KODE
PROGRAM
END-CDISPLAY]
Press the ► SHIFT
butten to make SETUP
blink and press the +
SET button.
MPIAY SMÍT -SET*
D 0 I J D I J
CLOCK ADJUST
I SETUP I
DISPLAY MODE
PROGRAM
END-CDISPLAY]
Example: When setting for a total of four fields at an interval
of 0.5 seconds.
I 4-fieIds recording i
O.Ssec
U LT
U
one field recording
Press the ► SHIFT button to make 1 SHOT REC
FIELD blink and press the + SET button to set the
number of recording fields.
l»fUiY SHIFT
lOOTKM SELECT
-SET+
O 0 § G ! J
ALAlUt REC TIME 15S
SPEED A ZH
ISHDT REC FIELD I ItJ
INTERVAL o.zs
RESTART REC OFF
TAPE END MODE STOP
ALARM STOP
NENU-CDISPLAY]
Each time pressing the + SET button the display changes
as follows.
1F-> 2F-> 4F ^ 8 F 1 6 F 3 2 F - ) MANUAL
Each time pressing the - SET button, the display changes
in the reverse direction.
Display Recording fields
IF 1 field
2F 2 fields
4F 4 fields
8F 8 fields
16F 16f ields
32F 32 fields
MANUAL Accepting the one-
shot input.
Note:
Because the head is constantly tracing the same location, it can cause damage to the head and tape. For this reason, if there is
no One-shot input when the time mode is set to L01, L02 or L03 the unit automatically records
2 fields every 1, 2 or 3 minutes to
protect the tape and heads. Choose the time mode suited to your particular purpose.
26