Toshiba KV-6200A - Manual (Page 6)

Rear Panel
é
®
BATTERY cover
® REMOTE jack
Accepts the plug from the remote control.
®
MIC IN jack
Accepts audio signals from a microphone, in this case the
RCA jack input will be switched off.
® ALARM IN terminal
Signal input terminal to start alarm recording.
The VCR goes to alarm recording mode when the terminal
is connected to the ground terminal during recording.
® ALARM RESET terminal
Signal input terminal to release alarm recording.
Alarm recording is released when the terminal is con­
nected to the ground terminal during alarm recording.
(D ALARM OUT terminal
Output terminal to transmit the alarm signal to an external
equipment.
A voltage of DC +5V is output during alarm recording.
® ONE SHOT IN terminal
■' Used for One-shot recording.
® REC TRIGGER OUT terminal
Signal output terminal to control the switching timing of tiie
camera when connected writh the sequential switcher.
® AUDIO IN jack (RCA type)
Used to record external audio signals by connecting to the
audio output jack of an external audio source.
. ® AUDIO OUT jack (RCA t^)
Used to connect to the audio input jack of external audio
equipment.
® VIDEO IN connector (BNC)
Used to record external video signals by connecting to the
video output jack of an external video source such as a
camera, etc.
® VIDEO OUT connector (BNC)
Used to connect to a monitor TV.
® POWER CORD
Insert to an 120V AC outlet.
Note:------------------------------------------------------------
This VCR allows recording of characters and numerical
information sent from the ATM (Automatic Tetter Machine),
Cash Register and superimposed on the screen by cwinect-
ing the specified l/P (Interface Board) to tire I/O connector on
rear of the unit.
When you wish to obtain the t/F Board, please consult
TOSHIBA AMERICA C.P. INC. (See MANUAL Back cover)
The mounting of the 1/F Board is allowed only by a qualified
service man.
For details on the mounting, refer to the Instruction Manual
supplied with the 1/F Board.