Toshiba KV-6200A - Manual (Page 36)

P
l a y b a c k o p e r a t i o n
IgLAYiXgll
Turn the power ON for the monitor TV.
'TIME LAPSE VCR-
UHd t 9«0Hour
Press the PLAY button.
REW F\AY FF
l<M| > IM>
Insert a tape which has been recorded on. Select the playback time mode.
me MODE
0 ^
H
^ ^ n n n n
► u u u u
o
t f
г
Tracking Adjustment
Use the V , A TRACKING button to adjust when noise appears on the playback screen.
TTWCKMQ
0 0
Press e№er v or a TRACKING button so that a
dearer picture is obtained.
When returning the tracking to a standard adjustment
value, press
a and v buttons simultaneously.
Hotesi
When restart recording is ON and a power failure occurs or the power cord has been removed and replaced, this unit will
automatically go to the recording mode.
When the PAUSE button is pressed during playback, the unit will carry cut still playback. To release, press the PAUSE or PLAY
button again. When still screen playback continues for more than 10 minutes the unit goes to playbadt mode.
Reverse playback is released after 1 minute and the unit returns to normal playback.
The time mode cannot be changed during reverse playback (only in A2-hour),
When playing back a tape that has been recorded in a time-lapse mode (A12-960 hours), pay attention to the following points.
• There wilt be some horizontal picture unstable, but this is not wrong with the unit.
• The upper section of the picture on the monitor screen may be distorted. This is not an abnormality.
When playing back tapes recorded in the various time modes, the picture may wobble somewhat depending on the time mode.
Recording time mode Time mode for playback
A2 hours, A12-960-hours A2 hours, A12-960-hours
The vertical picture unstable occurs during playback in the A12- and A24-hour modes. This is not an abnormality.
When returning to normal playback after picture search, the picture may wobble.
35