Cisco 700 - Manual (Page 45)

Installing Your Router 3-9
Connecting the Power Supply
Warning This product relies on the building’s installation for short-circuit
(overcurrent) protection. Ensure that a fuse or circuit breaker no larger than
120 VAC, 15A U.S. (240 VAC, 16A international) is used on the phase conductors
(all current-carrying conductors).
Warning This equipment is intended to be grounded. Ensure that the host is
connected to earth ground during normal use.
To connect the power supply, complete the following steps:
Step 1 Connect the round end of the power supply cable to the black circular power
connector on the rear panel of your router.
Step 2 Connect the black power supply cord to the black power supply.
Step 3 Connect the power supply cord to an electrical outlet. (See Figure 3-5.)
Figure 3-5 Connecting Power Supply (Cisco 765 shown)
Desktop power supply
DC power input
H5065
CONFIG
+5V ---1.5A +/-5%
-30V--- 0.2A +/-25%
S 0
ISDN S/T
Link NODE
HUB
10BASET