Cisco 700 - Manual (Page 93)

Terminal Communications B-7
Troubleshooting Software Downloads
If the download was not successful, use Table B-3, which shows symptoms and possible
solutions.
A combination of blinking LEDs indicates a software download problem. An error code is
also displayed on the terminal.
Table B-4 lists the combination of blinking LEDs that indicate an error, along with the error
code and a description of the error.
Table B-3 Software Download Command Troubleshooting
Symptom Probable Cause and Solution
Download takes
significantly longer than
the approximate time listed
in Table B-2. The terminal emulation program interline and intercharacter delays
are not set to zero. If the load was successful, no further action is
necessary. If the load was terminated prematurely, reset the interline
and intercharacter delays to zero, and reload the software.
The terminal displays
unrecognizable text after
the download is completed. The terminal has not been reset to 9600 baud. Reset the terminal
any time after loading the new software. After changing the
terminal baud rate, press Return to display the prompt (>).
Two or more LEDs are
blinking. Incorrect configuration of the PC COM port or a defective console
cable. Press Esc and try to load the software again.
Table B-4 LED Error Messages—Software Download
Blinking LED Error Code Description of Error
Line
CH 2
E-1 A framing, parity, or overflow error occurred during
software download, usually because of an incorrect data rate
or configuration port setting. Check the data rate and
configuration port settings.
CH 1 E-2 A colon was not at the beginning of a line in the new
software image file. Either the software image file is
corrupted or some characters were entered before the
download started. Start the software load process again. If
the same error occurs, replace the software image file.