Comtrol PROFINET IO - Manual

DeviceMaster UP PROFINET IO Installation Quick Start 2000484 Rev. E ­ 1
PROFINET IO Installation Quick Start
This document is intended to provide you with a way to locate software and installation documentation for the
DeviceMaster UP.
In addition, use this document to quickly configure:
•
Read‐only devices such as barcode scanners and some RFID readers
• Read/write devices such as printers and some weigh scales
B LUE CAPS link to external documents, which function if reading this document from the web/ftp site or CD. Red ,
underlined links go to the web site and blue , underlined links jump within the document and provide a page number.
Installation Overview
Use the following steps to install the DeviceMaster UP.
1.
I NSTALL THE HARDWARE .
2. Install PortVision DX from the CD or download and install
the latest version.
3. C ONFIGURE THE D EVICE M ASTER UP network settings using
PortVision DX.
4. Depending on the DeviceMaster UP model, do the following:
• Models without PROFINET IO loaded, you must install the
software assembly (.msi) from the CD or download and
install the latest file, which contains the PROFINET IO
firmware, GSDML, and bitmap for Step7. By default, these
files are saved in c:\Comtrol\ProfinetIO and are need for
Step 5
• Models with PROFINET IO loaded on the DeviceMaster UP, you should check to see if a later version of PROFINET
IO is available for installation. Check the PROFINET IO version in PortVision DX against the web site to see if a
later version is available. Typically, you should download and install the latest .msi file and upload the latest
version, which may include updates or enhancements.
Note: Models that have PROFINET IO loaded on the DeviceMaster UP are identified in PortVision DX and the
DeviceMaster UP is labeled accordingly.
5. I F NECESSARY , UPLOAD the PROFINET IO firmware into the DeviceMaster UP using PortVision DX.
Note: Do not perform Step 6 before Steps 1 through 5.
6. Configure the serial or Ethernet TCP/IP socket port characteristics using the DeviceMaster UP embedded web page
(Server Configuration).
If you have Read­only or read/write devices, you can use the appropriate procedures for your device, which are
located in this document:
•
Read‐only devices (barcode scanners and some RFID readers), go to Configuring Read­Only Serial Devices on
Page 2 or Configuring Read­Only Ethernet TCP/IP Devices on Page 4.
• Read/write devices (printers and some weigh scales), first perform the appropriate procedure for a read‐only
device and then go to Configuring Read/Write Devices on Page 6.
Software and Documentation Web
DeviceMaster UP Hardware Installation
and Configuration Guide
PortVision DX
PROFINET IO firmware
DeviceMaster UP Filtering and Data
Extraction Reference Guide