Comtrol DM ATS-XPe - Manual (Page 10)

10 Installation and Setup
Configuring the Network Settings on the ATS-XPE
3. Highlight Internet Protocol (TCP/IP) and select Properties.
4. Configure the network
connection to your network as
needed, and select Ok.
The default network settings for
the adapters are:
Adapter#1
IP Address
192.168.250.251
Subnet mask
255.255.255.0
Gateway 192.168.250.1
Adapter#2
IP Address
192.168.255.252
Subnet mask
255.255.255.0
Gateway 192.168.255.1
Note: The PCMCIA adapter is
set to obtain an IP
address and has no
default address unless it
is manually configured.
5. Select Ok to save the Local Area
Connection Properties sheet and Close the Network Connections control panel.
The network connection will be available momentarily.