Comtrol DM ATS-XPe - Manual (Page 15)

Installation and Setup 15
Setting Up Dial-In
4. To configure remote desktop
use, select the Log On tab, Allow
service to interact with desktop,
and Ok.
5. Close the Computer
Management console.
Setting Up Dial-In
Use the following procedure if you want to enable dial-in on the ATS-XPE. The
modem must be installed and configured before configuring dial-in. You must
start the Routing and Remote Access service before an Incoming Connections
entry appears in the Network Connections control panel.
If you need to create additional users, use the User Accounts control panel. A
password is required on any dial-in account. To use the default Administrator
account for dial-in, you must create a password for the account.
Note: See Installing Modems on Page 49, to install modems other than the Linksys
PCMCIA PCMLM56 modem.
1. Open the Network Connections control panel, right-click Incoming Connections,
and select Properties.
2. Check the appropriate entry under
Devices.