Comtrol DM ATS-XPe - Manual (Page 8)

8 Installation and Setup
Other Installation and Configuration Procedures
Other Installation
and Configuration
Procedures After the initial installation of the hardware there are other procedures you may
need to perform to complete installation and configuration of the ATS-XPE.
• If you want to connect and configure the ATS-XPE to a network (Ethernet or
PCMCIA wireless adapter), review and perform the appropriate procedures:
- PCMCIA wireless option, see Linksys Wireless PC Card (WPC11) on Page
43 to complete the wireless card installation.
- Configuring the Network Settings on the ATS-XPE on Page 9, for initial
setup of the Ethernet ports or the Linksys PCMLM56 Ethernet card.
- Changing the Default Computer and Workgroup Names on Page 11, if you
are configuring multiple ATS-XPE units on your network.
• If you installed a PCMCIA modem, perform the appropriate procedures:
- Starting Routing and Remote Access Services starting on Page 13, to start
remote services.
- Setting Up Dial-In on Page 15, if you want to configure the PCMCIA
modem for dial-up on the ATS-XPE.
• If you ordered the PC104 RocketPort option, see Configuring the RocketPort
Serial Ports on Page 26 before connecting your serial devices.
Note: Only install serial device drivers for the Windows XP Embedded
operating system. Refer to the Customer Support Policy on Page 56,
before installing any drivers.
• See Installing Modems starting on Page 49, if you want to connect an external
modem to the AUX A or CONSOLE ports.