Comtrol DM ATS-XPe - Manual (Page 9)

Installation and Setup 9
Configuring the Network Settings on the ATS-XPE
Configuring the Network Settings on the ATS-XPE
After installing the hardware, you are ready to configure the network. The ATS-
XPE provides Ethernet ports that function as two independent Ethernet network
interface cards and support for an optional wireless adapter in the PCMCIA slot.
See
Linksys Wireless PC Card (WPC11) on Page 43 for wireless configuration
procedures before configuring the network settings.
Each network port must be connected to a different network segment or the ports
will conflict with each other.
Note: If you did not connect a standard Ethernet cable between the Ethernet (1 or
2) or the PCMCIA (PCMLM56) Ethernet port that you want to configure and
the network hub, do so now.
Use the following procedure to configure the port for DHCP or a static IP address,
or to set DNS server addresses.
1. If necessary, log into the ATS-XPE and open the Network Connections control
panel.
2. Right-click on the enabled Local Area Network (LAN) Connection that you
want to configure and select Properties.